I use simpler method. Connect laser diode to 5 V supply and 470 Ohm resistor. No lasing – go lower with resistance, to 390 Ohms. No lasing, go lower to 330 Ohms, etc … until lasing starts.

AND gate implemented as diode-resistor logic. (Credit: Anthony Francis-Jones) The fun part about logic gates is that there are so many ways to make them, with each approach having its own ...

In DC voltage applications, the RC snubber network is typically wired across the relay contacts, whereas in standard AC ...

You can build a simple low-current voltage regulator from a resistor and a Zener diode. This type of regulator is often adequate for noncritical applications such as internal bias voltages. The ...

Molecular circuitry: International team breaks one-diode-one resistor electronics. ScienceDaily . Retrieved June 2, 2025 from www.sciencedaily.com / releases / 2020 / 06 / 200602114340.htm ...

By putting in a 6.8-Ω resistor, Pease caused the current through the LED to be 10 mA. 1. Bob Pease used an LM334 current source to servo the current from a PNP transistor through an LED diode.

Flexible organic memory devices are promising candidates for data storage applications. Here, Ji et al.develop a flexible all-organic 64-bit memory cell array possessing one diode–one resistor ...

Save guides, add subjects and pick up where you left off with your BBC account. To investigate the relationship between current and potential difference for a resistor, bulb and diode ...

Although a resistor is a linear current sensor, ... One diode from a matched pair is used for the emitter load (D2), and D3 is a reference diode employed to enable differential measurements.